Toyota
Toyota Land Cruiser
 Service Manual
Brake
Disassembly

1. REMOVE CYLINDER BOOTS

Using a screwdriver, remove the cylinder boot from the caliper.

Using a screwdriver, remove the cylinder boot from the caliper.

2. REMOVE PISTON

(a) Place a piece of cloth or a similar, object between the piston

(a) Place a piece of cloth or a similar, object between the piston and caliper.

(b) Use compressed air to remove the piston from the cylinder.

CAUTION: Do not place your fingers in front of the piston when using compressed air.

3. REMOVE PISTON SEALS FROM BRAKE CYLINDER

Using a screwdriver, remove the piston seals from the caliper.

Using a screwdriver, remove the piston seals from the caliper.

4. REMOVE PIN BOOT AND SLIDING BUSHING

Using a screwdriver, pull out sliding pin, pin boot and sliding bushing.

HINT: Tape the screwdriver tip before use.

NOTICE: At the time of reassembly, please refer to the following item.

Insert the sliding pin with sliding bushing into the lower part, and insert the sliding pin without sliding bushing into the upper part.

More about Brake:

Brake fluid

Brake pedal

Brake system

Front brake caliper

Front brake pad

Front speed sensor

Hydraulic brake booster

Proportioning and By-pass valve (P & B valve)

Parking brake

Parking brake lever

Rear brake caliper

Disassembly

Rear brake pad

Rear speed sensor

Troubleshooting

Toyota Land Cruiser Service Manual / Brake / Disassembly

Toyota Land Cruiser Service Manual

Categories


2011-2018 Copyright www.tlacruiser.com