Toyota Land Cruiser

 Service Manual

SFI » Front airbag sensor
Removal

NOTICE:

• If the wiring connector of the SRS is disconnected and the ignition switch is at ON position, DTCs will be recorded.
• Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
• Never reuse the sensor involved in a collision when the SRS has deployed.
• Never repair a sensor in order to reuse it.

1. REMOVE FRONT AIRBAG SENSOR LH

(a) Remove the battery carrier and battery.

(b) Disconnect the front airbag sensor connector.

NOTICE: Disconnect the connector with sensor assembly installed.

(c) Pull the windshield washer tank opening as shown in the illustration.

(d) Remove the 2 bolts and front airbag sensor LH.

2. REMOVE FRONT AIRBAG SENSOR RH

(a) Disconnect the front airbag sensor connector.

NOTICE: Disconnect the connector with sensor assembly installed.

(b) Remove the 2 bolts and front airbag sensor RH.

Inspection

Installation

Removal

Replacement