Toyota
Toyota Land Cruiser
 Service Manual
Suspension & Axle » Rear axle shaft
Removal

1. REMOVE REAR WHEEL

Torque: 131 N·m (1,340 kgf·cm, 97 ft·lbf)

2. DISCONNECT BRAKE LINE

Using SST, disconnect the brake line and remove the clip.

Using SST, disconnect the brake line and remove the clip.

SST 09023-00100

Torque: 15 N·m (150 kgf·cm, 11 ft·lbf)

3. REMOVE BRAKE CALIPER AND DISC

Remove the 2 bolts, washers, brake caliper and disc.

Remove the 2 bolts, washers, brake caliper and disc.

Torque: 103 N·m (1,050 kgf·cm, 76 ft·lbf)

4. CHECK BEARING BACKLASH AND AXLE SHAFT DEVIATION

(a) Using a dial indicator, check the backlash in the bearing

(a) Using a dial indicator, check the backlash in the bearing shaft direction.

Maximum: 0.6 mm (0.024 in.)

If the backlash exceeds the maximum, replace the bearing.

(b) Using a dial indicator, check the deviation at the surface of the axle shaft outside the hub bolt.

Maximum: 0.05 mm (0.0020 in.)

If the deviation exceeds the maximum, replace the axle shaft.

5. REMOVE PARKING BRAKE ASSEMBLY (BR-33 )

6. REMOVE AXLE SHAFT ASSEMBLY

(a) Remove the 4 nuts.

(a) Remove the 4 nuts.

Torque: 123 N·m (1,250 kgf·cm, 91 ft·lbf)

(b) Pull out the axle shaft assembly.

NOTICE: Be careful not to damage the oil seal.

(c) Remove the O-ring from the bearing case.

    More about «Rear axle shaft»:

    Disassembly

    Inspection

    Reassembly

    Removal

    Replacement

    Toyota Land Cruiser Service Manual / Suspension & Axle / Rear axle shaft / Removal

    Toyota Land Cruiser Service Manual

    Categories


    © 2011-2024 Copyright www.tlacruiser.com