Toyota
Toyota Land Cruiser
 Service Manual
SFI » Seat position sensor assembly
Installation

NOTICE:

  • Never use SRS parts from another vehicle. When replacing parts, replace them with new ones.
  • Never reuse the seat position sensor assembly involved in a collision when the airbag has deployed.
  • Never repair a sensor in order to reuse it.

1. INSTALL SEAT POSITION SENSOR ASSEMBLY

(a) Connect the connector.

(a) Connect the connector.

(b) Install the seat position sensor assembly with a new bolt.

Part No.:

Bolt: 90119-06871 Torque: 8.0 N·m (82 kgf·cm, 71 in.·lbf)

NOTICE:

  • Connection of the connector is done after the sensor assembly has been installed.
  • Make sure that the sensor assembly is installed with the specified torque.
  • If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one.
  • When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
  • After installation, shake the sensor assembly to check that there is no looseness.

2. INSTALL FRONT SEAT ASSEMBLY (DRIVER SIDE) (BO-1 17)

3. INSPECT SRS WARNING LIGHT (DI-692 )

    More about «Seat position sensor assembly»:

    Inspection

    Installation

    Removal

    Replacement

    Toyota Land Cruiser Service Manual / SFI / Seat position sensor assembly / Installation

    Toyota Land Cruiser Service Manual

    Categories


    © 2011-2024 Copyright www.tlacruiser.com