Toyota Land Cruiser

 Service Manual

Automatic Transmission
ATF temperature sensor

On-vehicle repair

1. REMOVE ENGINE NO.2 UNDER COVER

2. DRAIN ATF

3. REMOVE OIL PAN ( AT-1 1)

4. REMOVE OIL STRAINER ( AT-1 1)

5. REMOVE ATF TEMPERATURE SENSOR

(a) Disconnect the 7 solenoid valve connectors.

(b) Remove the 2 bolts and disconnect the 2 ATF temperature sensors.

(c) Disconnect the solenoid connector.

(d) Remove the bolt and the transmission wire harness.

6. INSTALL ATF TEMPERATURE SENSOR

(a) Install the transmission wire harness.

(b) Install the bolt.

Torque: 5.4 N·m (55 kgf·cm, 48 in.·lbf)

(c) Connect the solenoid connector.

(d) Connect the 7 solenoid valve connectors.

(e) Connect the 2 ATF temperature sensors with the 2 bolts.

Torque:
A: 11 N·m (112 kgf·cm, 8 ft·lbf) B: 10 N·m (100 kgf·cm, 7 ft·lbf)

Bolt length: Bolt A: 36 mm (1.42 in.) Bolt B: 12 mm (0.47 in.)

Sensor wire harness:

7. INSTALL OIL STRAINER ( AT-8 )

8. INSTALL OIL PAN ( AT-8 )

9. FILL ATF AND CHECK ATF LEVEL ( AT-3-1 )

10. INSTALL ENGINE NO.2 UNDER COVER

Air cooled oil cooler

ATF temperature sensor

Automatic transmission system

Automatic transmission unit

Floor shift assembly

Parking lock pawl

Park/neutral position (PNP) switch

Torque converter clutch and drive plate

Valve body assembly

Vehicle speed sensor