Toyota
Toyota Land Cruiser
 Service Manual
Propeller Shaft Propeller shaft assembly
Replacement

NOTICE: Be careful not to grip the propeller shaft tube too tightly in a vise as this will cause deformation.

REPLACE DUST COVER

(a) Remove the sleeve yoke from the propeller shaft.

(a) Remove the sleeve yoke from the propeller shaft.

  1.  Place matchmarks on the sleeve yoke and shaft.
  2.  Pull out the sleeve yoke from the shaft.

(b) Remove the dust cover.

(b) Remove the dust cover.

Cut the dust cover spirally at the pressing-in part with a saw and pry it off with a chisel and hammer.

NOTICE: Do not damage the propeller shaft. If damaged, replace the shaft with a new one.

(c) Install a new dust cover.

(c) Install a new dust cover.

Using SST and press, press in a new dust cover.

SST 09636-20010

NOTICE: Place the universal joint straight when pressing in the dust cover. Apply MP grease to the ''A'' part.

(d) Insert the sleeve yoke into the propeller shaft.

  1.  Apply MP grease to the propeller shaft spline and sleeve yoke sliding surface.
  2.  Align the matchmarks on the sleeve yoke and propeller shaft.
  3.  Install the propeller shaft into the sleeve yoke.
    More about Propeller shaft assembly:

    Inspection

    Removal

    Replacement

    Toyota Land Cruiser Service Manual / Propeller Shaft / Propeller shaft assembly / Replacement

    Toyota Land Cruiser Service Manual

    Categories


    2011-2018 Copyright www.tlacruiser.com