Toyota
Toyota Land Cruiser
 Service Manual
Body Mechanical
Hood support

REPLACEMENT

1. REMOVE HOOD SUPPORT

(a) Remove the bolt and hood support from the hood.

HINT: While supporting the hood by hand, remove the hood support from the hood.

(b) Remove the bolt and hood support.

2. IF NECESSARY, REPLACE HOOD SUPPORT

NOTICE: Handling the hood support

  • Do not disassemble the support as the cylinder is filled with pressurized gas.

  • If the hood support is to be replaced, drill a 2.0 - 3.0 mm (0.079 - 0.118 in.) hole in the area shown in the illustration to completely release the high pressure gas before disposing of it.
  • When drilling, chips may fly out so work carefully.
  • The gas is colorless, odorless and non - toxic.

    When working, handle the hood support carefully.

    Never score or scratch the exposed part of the piston rod, and allow any paint or oil to get on it.

  • Do not turn the piston rod and cylinder with the hood support fully extended.

3. INSTALL HOOD SUPPORT

(a) Install the bolt and hood support to the body.

(b) Install the bolt and hood support to the hood.

    More about «Body Mechanical»:

    Back door glass

    Back door stay

    Body outside moulding

    Clip

    Front bumper

    Front seat

    Front wiper and washer

    Hood

    Hood support

    Instrument panel

    Lower back door

    Quarter window glass

    Roof drip side finish moulding

    Rear bumper

    Rear door

    Rear No.1 Seat (LH)

    Rear No.1 Seat (RH)

    Rear No.2 Seat

    Roof headlining

    Rear wiper and washer

    Seat belt pretensioner

    Seat belt pretensioner

    Replacement

    Seat belt

    Sliding roof

    SRS airbag

    Upper back door

    Windshield

    Toyota Land Cruiser Service Manual / Body Mechanical / Hood support

    Toyota Land Cruiser Service Manual

    Categories


    © 2011-2024 Copyright www.tlacruiser.com