Toyota
Toyota Land Cruiser
 Service Manual
Suspension & Axle » Front axle hub
Disassembly

1. REMOVE OIL SEAL AND BEARING

(a) Using a screwdriver, pry out the oil seal.

(b) Remove the bearing from the axle hub.

2. REMOVE BEARING OUTER RACES

(a) Using a brass bar and hammer, remove the outside bearing

(a) Using a brass bar and hammer, remove the outside bearing outer race.

NOTICE: Be careful not to damage the ABS speed sensor rotor.

(b) Using a brass bar and hammer, remove the inside bearing

(b) Using a brass bar and hammer, remove the inside bearing outer race.

3. INSPECT BEARINGS

Clean the bearings and outer races and inspect them for wear or damage.

4. REMOVE DISC

(a) Mount the axle hub with the disc in a soft jaw vice.

(a) Mount the axle hub with the disc in a soft jaw vice.

NOTICE: Close vice until it holds disc, do not tighten further.

(b) Place matchmarks on the axle hub and disc.

(c) Remove the 5 bolts and separate the axle hub and disc.

    More about «Front axle hub»:

    Disassembly

    Installation

    Reassembly

    Removal

    Toyota Land Cruiser Service Manual / Suspension & Axle / Front axle hub / Disassembly

    Toyota Land Cruiser Service Manual

    Categories


    © 2011-2024 Copyright www.tlacruiser.com